Concentrations of hazardous heavy metals in environmental samples collected in Xiamen, China, as determined by vapor generation non-dispersive atomic fluorescence spectrometry.

Non-dispersive atomic fluorescence spectrometry (NDAFS) coupled with vapor generation (VG) sample introduction was applied to the determination of the concentrations of hazardous heavy metals, such as arsenic, cadmium, lead and mercury, in seawater, soils and total airborne particulate matter (PM) collected around the Xiamen area in China. Almost 100% sample introduction efficiency was achieved by using thiourea and ascorbic acid for the pre-reduction of As(V) to As(III), K3Fe(CN)6 and tartaric acid for pre-oxidation of Pb(II) to Pb(IV), and masking the interferences arising from the co-existing transition metals to As, Cd, Hg and Pb during their vapor generation process. Moreover, a novel sample pretreatment device was developed to avoid the loss of mercury, lead, cadmium and arsenic during sample pretreatment. With such methods, the detection limit (DL) of arsenic, cadmium, lead and mercury was down to 0.08, 0.03, 0.05, 0.01 ng mL(-1) (3sigma), respectively. The relative standard deviations (RSD, n = 11) for arsenic, cadmium, lead and mercury at 10 ng mL(-1) were 0.9%, 1.6%, 1.3% and 2.0%, respectively. The concentrations of hazardous heavy metals in the environmental samples collected in Xiamen, China are in the range from 0.02 +/- 0.001 ng mL(-1) in seawater to 15.3 +/- 0.2 microg g(-1) in soils. Besides flame/GF-AAS and ICP-AES/MS, VG-NDAFS should be another choice for the determination of hazardous heavy metals in environmental samples.     

利用声波控制超短脉冲的色散

 声光互作用器件声光可编程色散滤波器（AOPDF）是一种实时的色散补偿器件，它可用于飞秒啁啾脉冲放大系统。通过耦合模理论推导，得到了输出脉冲的群延迟与调制声波的频率、啁啾、带宽等参数的关系，并且对用2.5cm长的LiNbO₃作为声光晶体的AOPDF补偿飞秒光脉冲的色散进行了数值模拟，得到了对中心波长为800 mm的钛宝石飞秒激光色散补偿特性及所需声波的频率和啁啾参数。     

基于Apollo信号控制台的NQR炸药探测方法

介绍了一种基于Apollo信号控制台的核四极矩共振（NQR）炸药探测方法，描述了系统的结构组成、工作原理和实现方法，并给出了对RDX的测试试验结果. 试验表明该方法可实现对RDX信号的探测.     

掺氢与激励电路对钡蒸气激光输出特性的影响

对用Blumlein电路放电激励的钡蒸气激光在掺氢和不掺氢时的输出特性进行了实验研究.结果表明，用掺氢1.5%的氖气作缓冲气体能使激光功率增加近2倍.在此基础上，进一步比较了相互作用电路与Blumlein电路时钡蒸气激光的输出特性，发现相互作用电路能显著提高钡蒸气激光的输出功率和效率，获得了3W最大功率和0.4%效率的1.5μm波长激光输出.测量并分析了各工作参量与激光功率之间的关系，定性解释了掺氢与相互作用电路的作用机理 . 关键词： Blumlein电路 相互作用电路 掺氢 钡蒸气激光     

Synthesis of Novel Monomeric Dyes with Anthraquinone Residue

Two novel polymerizable dyes with anthraquinone residue have been prepared, and their structures were characterized by FTIR, ^1HNMR and EA.     

硅基两维光子晶体的制备和光子带隙特性

利用反应离子束刻蚀设备制备了硅基的两维空气柱光子晶体，并用红外显微镜测试了样品的 反射谱. 理论上用时域有限差分(FDTD)方法计算了样品的光子带隙，从测试结果看光子带隙 和理论计算的光子带隙符合得很好.  关键词： 光子晶体 光子带隙 反射谱 时域有限差方法     

Compression Behaviour of Ni77P23 Amorphous Alloy up to 30.5 GPa

The compression behaviour of Ni77P23 amorphous alloy is investigated at room temperature in a diamond-anvil cell instrument using in-situ high pressure energy dispersive x-ray diffraction with a synchrotron radiation source. The equation of state is determined by fitting the experimental data according to the Birch-Murnaghan equation. It is found that the structure of Ni77P23 amorphous alloy is stable under pressures up to 30.5 GPa. Within the pressure range from zero to the experimental one, the pressure-induced structural relaxation is reversible.     

两个不等式的加强与证明

本文利用幂平均加强了林同坡不等式和Ｓｔｏｌａｒｓｋｙ不等式，并给出了证明．     

H2S·HOH or H2O·HSH, which is more stable in the water-hydrogen sulfide complex?

High-level ab initio calculations are carried out to study the relative stability of the two hydrogen bonded structures of water-hydrogen sulfide complex, one with water as the proton donor (A) and the other with hydrogen sulfide as the proton donor (B). The results show that structure A is considerably more stable than B at the correlated level, which is in contrast with previous results obtained from Hartree-Fock calculations.     

Chemical synthesis and electric properties of the conducting copolymer of aniline and o‐aminophenol

A copolymer, poly(aniline‐co‐o‐aminophenol), was prepared chemically by using ammonium peroxydisulfate as an oxidant. The monomer concentration ratio of o‐aminophenol to aniline strongly influences the copolymerization rate and properties of the copolymer. The optimum composition of a mixture for the chemical copolymerization consisted of 0.3 M aniline, 0.021 M o‐aminophenol, 0.42 M ammonium peroxydisulfate, and 2 M H₂SO₄. The result of cyclic voltammograms in a potential region of ?0.20 to 0.80 V (vs.SCE) indicates that the electrochemical activity of the copolymer prepared under the optimum condition is similar to that of polyaniline in more acid solutions. However, the copolymer still holds the good electrochemical activity until pH 11.0. Therefore, the pH dependence of the electrochemical property of the copolymer is improved, compared with poly(aniline‐co‐o‐aminophenol) prepared electrochemically, and is much better than that of polyaniline. The spectra of IR and ¹H NMR confirm that o‐aminophenol units are included in the copolymer chain, which play a key role in extending the usable pH region of the copolymer. The visible spectra of the copolymers show that a high concentration ratio of o‐aminophenol to aniline in a mixture inhibits the chain growth. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 5573–5582, 2007